Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 41 handleidingen die deze stap bevatten.

Engels
Nederlands

Stap 1 vertalen

Stap 1
If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched. Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. During reassembly, connect this end first as it does not flex.
  • If your I/O Board cable's connectors have notches in the padding, you will need to release a locking lever underneath the notch in order to remove the cable. If this is the case, don't pry up on the connector until the levers are unlatched.

  • Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board.

  • During reassembly, connect this end first as it does not flex.

  • In a similar fashion, remove the I/O Board connector from its socket on the I/O Board.

  • Remove the I/O Board cable from the MacBook Pro.

Gebruik het platte einde van een spudger om de aansluiting van het I/O-bord in een rechte beweging uit het contact op het logic board omhoog te duwen. Zorg dat je, bij het weer aansluiten van deze kabel, eerst dit einde bevestigt, aangezien het niet meebeweegt.

Verwijder, op eenzelfde wijze, de aansluiting van het I/O-bord uit het contact op het I/O-bord.

Verwijder de I/O-bordkabel uit de MacBook Pro.

[* icon_note] If your I/O Board cable's connectors have [link|https://guide-images.cdn.ifixit.com/igi/NcprwYqAITaNGRVg.full|notches in the padding], you will need to '''release a locking lever underneath the notch''' in order to remove the cable. If this is the case, '''don't pry up on the connector until the levers are unlatched'''.
[*
black] Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. On
[* icon_reminder] During
reassembly, connect this end first as it does not flex.
[* icon_note] If your I/O Board cable's connectors have [link|https://guide-images.cdn.ifixit.com/igi/NcprwYqAITaNGRVg.full|notches in the padding], you will need to '''release a locking lever underneath the notch''' in order to remove the cable. If this is the case, '''don't pry up on the connector until the levers are unlatched'''.
[*
black] Using the flat end of a spudger, pry the I/O Board connector straight up out of its socket on the logic board. On
[* icon_reminder] During
reassembly, connect this end first as it does not flex.
[* black] In a similar fashion, remove the I/O Board connector from its socket on the I/O Board.
[* black] Remove the I/O Board cable from the MacBook Pro.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.