Ga door naar hoofdinhoud
Engels
Nederlands
Stap 2
Use a Y000 driver to remove three 1.1 mm screws from one side of the display EMI shield. If you have trouble loosening these screws, press the driver harder onto the screw as you turn it. If necessary, use the flat edge of your spudger to brace each display clip from behind so you can apply more pressure to the screws, without bending the clips.
  • Use a Y000 driver to remove three 1.1 mm screws from one side of the display EMI shield.

  • If you have trouble loosening these screws, press the driver harder onto the screw as you turn it. If necessary, use the flat edge of your spudger to brace each display clip from behind so you can apply more pressure to the screws, without bending the clips.

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.