Ga door naar hoofdinhoud
Engels
Nederlands
Stap 10
Use a pair of long-nosed pliers to remove the kickstart spring. When the tension is released, the pawl will pop off the end of the shaft. Note the washer and circlip arrangement under the spring (if fitted). This is a modification on later gearboxes to prevent premature wear of the layshaft bearing.
Remove the kick start spring and pawl
  • Use a pair of long-nosed pliers to remove the kickstart spring.

  • When the tension is released, the pawl will pop off the end of the shaft.

  • Note the washer and circlip arrangement under the spring (if fitted). This is a modification on later gearboxes to prevent premature wear of the layshaft bearing.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.