Repareer je spullen Gemeenschap Winkel

연결부 납땜 및 납제거 방법

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden de handleiding die deze stap bevat.

Terug naar de handleiding
Engels
Koreaans
Stap 5
How To Solder and Desolder Connections: stap 0, afbeelding 1 van 3 How To Solder and Desolder Connections: stap 0, afbeelding 2 van 3 How To Solder and Desolder Connections: stap 0, afbeelding 3 van 3

  • Thread the component leads through the circuit board holes. Most components should lie flat, close to the board.

  • Double-check the orientation if the component is electrically directional (such as diodes, LEDs, and electrolytic capacitors).

  • Diodes normally have a bar indicating the cathode (-). LEDs have a shorter lead on the cathode (-) and a flat spot on the dome.

부품 리드를 회로 기판 구멍에 끼워 넣으세요. 대부분의 부품들은 보드에 가깝게 평평하게 놓여야 합니다.

부품들이 전기적 방향이 있는 경우(예: 다이오드, LED, 전류 콘덴서)방향을 다시 한 번 확인하세요.

다이오드에는 일반적으로 음극(-)을 나타내는 막대가 있습니다. LED는 음극(-)의 리드가 짧고 돔에 평평한 점이 있습니다.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.