Ga door naar hoofdinhoud

iPhone 4S 배터리 교체하기

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 20 handleidingen die deze stap bevatten.

Stap 5
iPhone 4S Battery Replacement: stap 0, afbeelding 1 van 2 iPhone 4S Battery Replacement: stap 0, afbeelding 2 van 2
  • Insert the edge of a plastic opening tool between the battery and the outer case near the bottom of the iPhone.

  • Run the plastic opening tool along the right edge of the battery and pry up at several points to completely separate it from the adhesive securing it to the outer case.

  • If the adhesive is too strong, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery.

  • Wait about one minute for the alcohol solution to weaken the adhesive.

  • Use the flat end of a plastic opening tool to gently lift the battery.

  • Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

배터리와 iPhone 하단 근처 외부 케이스 사이에 플라스틱 여는 도구 가장자리를 끼우세요.

플라스틱 여는 도구를 배터리 오른편 가장자리를 따라 밀며 올려서 외부 케이스에 고정하는 여러 지점의 접착제를 완전히 분리하세요.

접착제가 너무 강하면 배터리 가장자리 아래에 고농도 (90% 이상) 이소프로필 알코올 몇 방울을 떨어뜨리세요.

알코올 용액이 접착제를 약화시킬 때까지 약 1분 동안 기다리세요.

플라스틱 여는 도구의 평평한 끝을 사용하여 배터리를 살살 들어 올리세요.

배터리를 강제로 빼려고 하지 마세요. 필요하다면 알코올을 몇 방울 더 떨어뜨려 접착제를 더 약화시키세요. 절대로 들어올리는 도구로 배터리를 변형하거나 구멍을 내지 마세요.

휴대폰에 알코올 용액이 남아 있는 경우 새 배터리를 설치하기 전에 조심히 닦아내거나 자연 건조하세요.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.