Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands

Stap 2 vertalen

Stap 2
Remove the faulty EM10 filter.  Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers, being careful not to pull the copper tracks off the motherboard. A replacement EM10 filter is available HERE  (as at 01/01/12) no doubt other suppliers exist Solder new EM10 filter into place, ensuring correct orientation.  If required, check the new filter with a multimeter to confirm before installing.
  • Remove the faulty EM10 filter. Use a soldering iron to melt the solder and gently lift off the filter with tweezers or pliers, being careful not to pull the copper tracks off the motherboard.

  • A replacement EM10 filter is available HERE (as at 01/01/12) no doubt other suppliers exist

  • Solder new EM10 filter into place, ensuring correct orientation. If required, check the new filter with a multimeter to confirm before installing.

  • Alternate method - Bridge the solder pads that correspond with each set of pads - yellow to yellow and cyan to cyan

  • Bypassing the EM10 filter may affect the system performance and is not recommended

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.