Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands
Stap 10
Apply flux to the positive contact of the battery on the PCB (Incidental finding is a SMD fuse F1 on this PCB) Using desoldering braid unsolder the positive contact from the PCB. Apply some gentle pressure with a small tool to remove the battery.
  • Apply flux to the positive contact of the battery on the PCB (Incidental finding is a SMD fuse F1 on this PCB)

  • Using desoldering braid unsolder the positive contact from the PCB.

  • Apply some gentle pressure with a small tool to remove the battery.

  • The battery should remove easily. If it does not, double check the battery contacts on the PCB to ensure they are not still connected somewhere. Another going over with the soldering iron may be required to complete that task.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.