Ga door naar hoofdinhoud
Stap 8
There are three places that will have to be desoldered. Positive battery contact Negative battery contact
  • There are three places that will have to be desoldered.

  • Positive battery contact

  • Negative battery contact

  • and a jumper

  • For the jumper the only thing required is to remove the solder between the pads.

  • Apply some flux to the jumper. The pliers will help to stabilize the PCB during soldering. any other means to hold it steady can be used.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.