Ga door naar hoofdinhoud

Stap 10 vertalen

Stap 10
Using a T27 Screwdriver head, reinstall the clutch inspection cover. Install the screws in the following order: Top
  • Using a T27 Screwdriver head, reinstall the clutch inspection cover. Install the screws in the following order:

  • Top

  • Bottom

  • Left

  • Right

  • Once all of the screws have been lightly hand-tightened, use a torque wrench to tighten them to their proper specification of 7 - 12 ft-lbs (84 - 108 in-lbs). Tighten the screws in the same order as before.

使用T27螺丝刀重新安装离合器检查盖。请按照以下顺序安装。

顶部

底部

一旦所有的螺丝被拧上了,请使用已经调整到7 - 12 ft-lbs (84 - 108 in-lbs)的扭矩扳手按照上述顺序拧紧。

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.