Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands
Stap 9
Before re-installing the primary chain inspection cover, make sure the rubber O-ring on the inside of the primary chain inspection hole is clean and properly seated. Also make sure that the rubber o-rings are clean and in proper condition before replacing the screws in the primary chain inspection cover. Using a 5/32" Hex or Allen screw head, re-install the primary chain inspection cover.
Re-assembly
  • Before re-installing the primary chain inspection cover, make sure the rubber O-ring on the inside of the primary chain inspection hole is clean and properly seated.

  • Also make sure that the rubber o-rings are clean and in proper condition before replacing the screws in the primary chain inspection cover.

  • Using a 5/32" Hex or Allen screw head, re-install the primary chain inspection cover.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.