Ga door naar hoofdinhoud
Engels
Nederlands
Stap 6
Unhook connector for small ribbon cable which connects control board on top of cube with circuit board on bottom of cube. Flip cube over (carefully supporting the inside mechanism--its not attached to the case anymore) and then lift case off. Don't go yanking it away brusquely, that control cable may have gotten pinned underneath even though you disconnected it.
Remove top of case
  • Unhook connector for small ribbon cable which connects control board on top of cube with circuit board on bottom of cube.

  • Flip cube over (carefully supporting the inside mechanism--its not attached to the case anymore) and then lift case off. Don't go yanking it away brusquely, that control cable may have gotten pinned underneath even though you disconnected it.

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.