Ga door naar hoofdinhoud
Engels
Nederlands

Stap 1 vertalen

Stap 1
In order to access the flash assembly, you need to remove several interior components from the body of the camera. With a Phillips #00 screwdriver, unscrew the two 3mm screws from the right side of the casing. Raise the flash by pressing the shutter button or lifting the flash up with your fingers to access the two body screws underneath.
  • In order to access the flash assembly, you need to remove several interior components from the body of the camera.

  • With a Phillips #00 screwdriver, unscrew the two 3mm screws from the right side of the casing.

  • Raise the flash by pressing the shutter button or lifting the flash up with your fingers to access the two body screws underneath.

  • Using the Phillips #00 screwdriver, unscrew the two 3mm screws by twisting counterclockwise.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.