Skip to main content

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 22 handleidingen die deze stap bevatten.

Step 4
Disconnect the digitizer cable by prying it straight up from its socket on the logic board. When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.
  • Disconnect the digitizer cable by prying it straight up from its socket on the logic board.

  • When reconnecting the digitizer cable, do not press the center of the connector. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Löse mit dem flachen Ende eines Spudgers oder einem Fingernagel den Stecker des Digitizerkabels vom Logic Board, indem du es gerade nach oben hebelst.

Wenn du das Kabel wieder verbindest drücke nicht in der Mitte des Steckers. Drücke erst an einem Ende, dann am gegenüberliegenden. Beim Drücken in der Mitte des Kabels kann der Stecker verbiegen und beschädigt werden.

[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* black] Use the flat end of a spudger, or a fingernail, to disconnectDisconnect the digitizer cable by prying it straight up from its socket on the logic board.
[* icon_caution] When reconnecting the digitizer cable, '''do not press the center of the connector'''. Press one end of the connector, then press the opposite end. Pressing in the center of the connector can bend the component and cause digitizer damage.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.