Ga door naar hoofdinhoud
Stap 6
There are four stripping holes of varying sizes on the wire stripper. Carefully position the cable in the largest (innermost) hole on the wire stripper and line up the edge of the jaws with the mark you just made as seen in the first picture. Squeeze the wire stripper to remove the outer cord tubing, revealing wire strands beneath.
  • There are four stripping holes of varying sizes on the wire stripper.

  • Carefully position the cable in the largest (innermost) hole on the wire stripper and line up the edge of the jaws with the mark you just made as seen in the first picture.

  • Squeeze the wire stripper to remove the outer cord tubing, revealing wire strands beneath.

  • If necessary, slide the outer sheath off the end of the cable.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.