Ga door naar hoofdinhoud
Engels
Nederlands

Stap 3 vertalen

Stap 3
Peel the black tape off the back of the LCD. Using the Phillips #00 remove the four 3mm screws on the LCD bracket. Remove the two 2mm screws from the top of the bracket.
  • Peel the black tape off the back of the LCD.

  • Using the Phillips #00 remove the four 3mm screws on the LCD bracket.

  • Remove the two 2mm screws from the top of the bracket.

  • Use a spudger to pop the LCD screen out of the camera’s backplate.

  • When the bracket comes off, the buttons from the top section may fall out of place. If this happens then put them back in the position they were in.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.