Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Stap 2
Unscrew the Torx #8 screws holding the hard drive case in place on the logic board. Lift up on the hard drive to disconnect its ribbon cable from the logic board, just like in the previous steps.
  • Unscrew the Torx #8 screws holding the hard drive case in place on the logic board.

  • Lift up on the hard drive to disconnect its ribbon cable from the logic board, just like in the previous steps.

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.