Vertaal stap #10 - How to Rebuild and Replace the Coils in a Mutation X V4 Atomizer - iFixit

Repareer je spullen

Recht op reparatie

Winkel

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 10 vertalen

Stap 10

Put one end of the coil in an outermost hole on side of screw and other end in one of the inner holes.

CAUTION: Alternate holes when placing wire inside of screws to avoid shorting the product. EX: holes 1 & 3 and holes 2 & 4 on the above picture

Put one end of the coil in an outermost hole on side of screw and other end in one of the inner holes.
CAUTION: Alternate holes when placing wire inside of screws to avoid shorting the product. EX: holes 1 & 3 and holes 2 & 4 on the above picture

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.