Ga door naar hoofdinhoud
Engels
Nederlands
Stap 20
With the logic board facing down, push the pins of the new connector through the holes in the logic board, making sure each pin goes through the board. DO NOT use excessive force, as you can bend the pins. DO NOT use excessive force, as you can bend the pins.
  • With the logic board facing down, push the pins of the new connector through the holes in the logic board, making sure each pin goes through the board.

  • DO NOT use excessive force, as you can bend the pins.

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.