Ga door naar hoofdinhoud
Engels
Nederlands
Stap 19
Once all solder is removed, pry the dock connector straight down from the logic board using a metal spudger. DO NOT remove the dock connector before all solder is removed, as the pins will rip from the dock connector and get stuck in the logic board.
  • Once all solder is removed, pry the dock connector straight down from the logic board using a metal spudger.

  • DO NOT remove the dock connector before all solder is removed, as the pins will rip from the dock connector and get stuck in the logic board.

  • If done properly, you should be able to see straight through the logic board where all 30 pins and the two metal joints used to be.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.