Ga door naar hoofdinhoud

Handspring Visor Edge Flip Cover Replacement

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 5 handleidingen die deze stap bevatten.

Engels
Nederlands

Stap 1 vertalen

Stap 1
Handspring Visor Edge Flip Cover Replacement: stap 0, afbeelding 1 van 2 Handspring Visor Edge Flip Cover Replacement: stap 0, afbeelding 2 van 2
  • Open the Visor Edge placing the screen and the inner part of the flip cover face down on a flat surface such as a table

  • On the back of the PDA there is a tab connecting the flip cover to the device. Push gently on this tab trying to slide the cover upwards along the surface then lift the pieces apart to fully detach them

  • Do not pull or tug on the flip cover in an attempt to remove it from the PDA this can result in the cover snapping causing damage to the device

  • To reassemble push the downward on the flip cover where there is an indent on the PDA indicating where the pieces connect. Finally, push the cover until it snaps into place.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.