Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 8 handleidingen die deze stap bevatten.

Stap 1 vertalen

Stap 1
Use a spudger to pry up the fan connector out of its socket on the logic board. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.
  • Use a spudger to pry up the fan connector out of its socket on the logic board.

  • It is useful to twist the spudger axially from beneath the fan cable wires to release the connector.

  • The fan socket and the fan connector can be seen in the second and third pictures. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same.

Usa uno spudger per estrarre il connettore della ventola dalla sua presa sulla scheda madre.

Può essere utile fare leva verticalmente con lo spudger da sotto i cavi del connettore per rimuovere quest'ultimo.

Le foto 2 e 3 mostrano la presa e il connettore della ventola. Fai attenzione a non rompere la presa di plastica sulla scheda madre quando usi lo spudger per sollevare il connettore dalla presa stessa. Il layout della scheda madre può essere leggermente diverso da quello nella foto 2, ma la presa della ventola è uguale.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.