Ga door naar hoofdinhoud
Engels
Nederlands

Stap 1 vertalen

Stap 1
Insert a spudger into the side to pop out one side of the brush holder. Repeat the  same step, but now on the other side of the brush holder. Lift the gray plastic piece up carefully to expose the motor.
Brush Motor Removal
  • Insert a spudger into the side to pop out one side of the brush holder.

  • Repeat the same step, but now on the other side of the brush holder.

  • Lift the gray plastic piece up carefully to expose the motor.

  • Do not pull up too hard because you could snap a wire attached to the motor or motor circuit board.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.