Ga door naar hoofdinhoud
Stap 3
Repeat for the left clip. Again, using a combination of a spudger and plastic opening tool to evenly pull the plastic clip up out of its channel in the heat sink. When there is enough of a gap between the fan and the heat sink, insert the spudger between the two, and pry up to remove the fan. When there is enough of a gap between the fan and the heat sink, insert the spudger between the two, and pry up to remove the fan.
  • Repeat for the left clip. Again, using a combination of a spudger and plastic opening tool to evenly pull the plastic clip up out of its channel in the heat sink.

  • When there is enough of a gap between the fan and the heat sink, insert the spudger between the two, and pry up to remove the fan.

Repita para el clip izquierdo. De nuevo, use una combinación de un spudger y una herramienta de apertura de plástico para extraer uniformemente el clip de plástico de su canal en el disipador de calor.

Cuando haya suficiente espacio entre el ventilador y el disipador de calor, inserte el spudger entre los dos, y haga palanca para quitar el ventilador.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.