Ga door naar hoofdinhoud
Stap 2
The fan is held onto the heat sink with four sturdy plastic clips. By prying the two exposed clips up out of their channel in the heat sink, you'll be able to tilt the fan up and off of the heat sink. Use a spudger and plastic opening tool to gently and evenly pry the right clip up out of its channel in the heat sink.
  • The fan is held onto the heat sink with four sturdy plastic clips. By prying the two exposed clips up out of their channel in the heat sink, you'll be able to tilt the fan up and off of the heat sink.

  • Use a spudger and plastic opening tool to gently and evenly pry the right clip up out of its channel in the heat sink.

  • Be careful not to put pressure downward onto the motherboard, or to pull the heat sink up against the motherboard.

El ventilador se mantiene en el disipador de calor con cuatro clips de plástico resistentes. Al levantar los dos clips expuestos de su canal en el disipador de calor, podrá inclinar el ventilador hacia arriba y hacia afuera del disipador de calor.

Use un spudger y una herramienta de apertura de plástico para hacer palanca suavemente y de manera uniforme el clip derecho de su canal en el disipador de calor.

Tenga cuidado de no presionar hacia abajo en la placa base, o para tirar del disipador de calor contra la placa base.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.