Ga door naar hoofdinhoud
Engels
Nederlands
Stap 7
Lift board up slightly to reveal 2 ribbon flex and 1 wire connector still attached beneath board-remove flex before lifting board off completely.
  • Lift board up slightly to reveal 2 ribbon flex and 1 wire connector still attached beneath board-remove flex before lifting board off completely.

  • Remove bottom flex first.

  • Then use fingernails to gently pull out wire connector from lens.

  • And slide tabs on connectors from lens/shutter and lens screen horizontally away from board and then slide flex cables free.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.