Ga door naar hoofdinhoud
Engels
Nederlands
Stap 15
After removing a loop of copper tape around the digitizer connector, the display assembly can finally be separated from the logic board. A copper shield fastened to the back of the battery can also be removed at this point.
  • After removing a loop of copper tape around the digitizer connector, the display assembly can finally be separated from the logic board.

  • A copper shield fastened to the back of the battery can also be removed at this point.

  • Presumably, the rear case is thin enough to warrant a copper shield for either heat dispersion or EMI protection, or both.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.