Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands
Stap 19
With the heatsink bracket removed the DMD board can be removed from the rear cover. It can help to start removing the board by pulling out on the upper right edge. Then, pull on the right side of the board.
  • With the heatsink bracket removed the DMD board can be removed from the rear cover.

  • It can help to start removing the board by pulling out on the upper right edge.

  • Then, pull on the right side of the board.

  • The board should then pivot out from the right. It is a snug fit but it should remove with care.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.