Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands
Stap 18
With the DMD board exposed, proceed to remove the four screws that hold the heatsink bracket to the board. DO NOT touch the screws highlighted in red.
  • With the DMD board exposed, proceed to remove the four screws that hold the heatsink bracket to the board.

  • DO NOT touch the screws highlighted in red.

  • These three screws highlighted in red are for adjustment of the DLP chip/DMD board. If you touch them you will throw off the factory adjustment of your chip.

  • With the four screws highlighted in green removed you can remove the heatsink bracket.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.