Ga door naar hoofdinhoud
Engels
Nederlands

Stap 1 vertalen

Stap 1
To begin removing the right speaker, lift the speaker wire with a screwdriver or spudger. Make sure to lift the wire up until the glued parts of the wire are completely separated from the device. Be careful and gentle when removing the wire connection for the speaker. You may want to use a heat source, such as a heat gun or a blow dryer, to dissipate the glue.
Right Speaker
  • To begin removing the right speaker, lift the speaker wire with a screwdriver or spudger.

  • Make sure to lift the wire up until the glued parts of the wire are completely separated from the device.

  • Be careful and gentle when removing the wire connection for the speaker. You may want to use a heat source, such as a heat gun or a blow dryer, to dissipate the glue.

  • After carefully removing the speaker flat-topped connector ,remove the 1.33x2.00mm Phillps screw, as shown in the third picture.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.