Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands
Stap 2
Use an iPod opening tool to slightly lift the top edge of the connector cover away from the logic board. Use the tip of a spudger to pull the connector cover retaining clips away from the inner frame. Remove the connector cover from the iPhone.
  • Use an iPod opening tool to slightly lift the top edge of the connector cover away from the logic board.

  • Use the tip of a spudger to pull the connector cover retaining clips away from the inner frame.

  • Remove the connector cover from the iPhone.

  • Before reassembly, be sure to clean all metal-to-metal contact points on the connector cover with a de-greaser such as windex. The oils on your fingers have the potential to cause wireless interference issues.

  • There is a tiny metal part on the top screw hole, make sure this stays on. It's a key part of the wireless and GPS antenna.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.