Skip to main content

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 4 handleidingen die deze stap bevatten.

Step 5
When disconnecting the following connectors, only pry up on the connector, not the socket on the logic board or you risk permanent damage. Use the flat end of a spudger to lift the power button and flash assembly cable connector up off of its socket. Lift the volume control cable connector up out of its socket on the logic board.
  • When disconnecting the following connectors, only pry up on the connector, not the socket on the logic board or you risk permanent damage.

  • Use the flat end of a spudger to lift the power button and flash assembly cable connector up off of its socket.

  • Lift the volume control cable connector up out of its socket on the logic board.

Quando scolleghi i connettori seguenti, fai leva solo sul connettore e non sul suo zoccolo sulla scheda logica per evitare il rischio di danni permanenti.

Usa l'estremità piatta di uno spudger per sollevare dalla sua presa il connettore del cavo del pulsante di accensione e del gruppo flash.

Stacca dal suo zoccolo sulla scheda logica il connettore del cavo del controllo volume.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.