Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 18 handleidingen die deze stap bevatten.

Stap 9
Remove the following Phillips screws securing the front panel assembly cable bracket:
  • Remove the following Phillips screws securing the front panel assembly cable bracket:

  • Three 1.2 mm screws

  • One 1.5 mm screw

  • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.

保持前面板张开立起约90度,卸下前面板排线固定板上的五颗Phillips螺丝。

三颗1.2 mm螺丝

一颗1.7 mm螺丝

一颗3.1mm螺丝

[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''
[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.