Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 18 handleidingen die deze stap bevatten.

Stap 9
Remove the following Phillips screws securing the front panel assembly cable bracket:
  • Remove the following Phillips screws securing the front panel assembly cable bracket:

  • Three 1.2 mm screws

  • One 1.5 mm screw

  • One 2.9 mm screw

  • Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.

Tout en tenant l'écran ouvert à un angle de 90°, enlevez les vis suivantes qui maintiennent le cache des connecteurs de l'écran :

Trois vis cruciformes Phillips #00 de 1,2mm

Une vis cruciforme Phillips #00 de 1,5mm

Une vis cruciforme Phillips #00 de 2,9mm

[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''
[* black] While holding the front panel open at about a 90º angle, removeRemove the following Phillips screws securing the front panel assembly cable bracket:
[* red] Three 1.2 mm Phillips #00 screws
[* orange] One 1.5 mm Phillips #00 screw
[* yellow] One 2.9 mm Phillips #00 screw
[* icon_caution] '''Do not attempt to insert longer screws into the red marked screw holes. Doing so may result in irreparable damage to the logic board.'''

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.