Ga door naar hoofdinhoud
Engels
Nederlands
Stap 9
This step involves removal of the top camera and speaker module. Read the next two steps before starting, as it is easy to rip one ribbon cable if you pry the part too far Insert your spudger as shown. This will involve some pressure, but the right side of the module should begin to lift from the frame My hand was covering the exact entry point, but you will want to further separate the module from the top left side of the phone (I'm holding it upside down)
  • This step involves removal of the top camera and speaker module. Read the next two steps before starting, as it is easy to rip one ribbon cable if you pry the part too far

  • Insert your spudger as shown. This will involve some pressure, but the right side of the module should begin to lift from the frame

  • My hand was covering the exact entry point, but you will want to further separate the module from the top left side of the phone (I'm holding it upside down)

  • Be very careful when lifting from the third spot - you only want to separate the clips on the side, if you lift the entire piece out of the phone, you can easily rip a ribbon cable underneath the assembly. See the next step for directions on how to fully remove the module

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.