Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Stap 1 vertalen

Stap 1
Remove the four 6 mm screws that secure the button controller PCB to the rest of the device; you will need a Phillips #2 driver for this task. Note: Since the main board is on top of this PCB, you may need to move the main board out of the way to access the screws.
  • Remove the four 6 mm screws that secure the button controller PCB to the rest of the device; you will need a Phillips #2 driver for this task.

  • Note: Since the main board is on top of this PCB, you may need to move the main board out of the way to access the screws.

  • Lift the PCB away from the rest of the device.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.