Repareer je spullen

Recht op reparatie

Winkel

Terug naar de handleiding
Engels
Nederlands
Stap 8
The replacement cable should be tinned with solder before solder on the board; just put the leads in place and apply heat to install it. Bending the wire tips 90 degrees helps with installation.

  • The replacement cable should be tinned with solder before solder on the board; just put the leads in place and apply heat to install it.

  • Bending the wire tips 90 degrees helps with installation.

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.