Ga door naar hoofdinhoud
Engels
Nederlands
Stap 3
The rear cover on this style of motor is held in place by four rivets that are compressed in to holes in the gear housing.
  • The rear cover on this style of motor is held in place by four rivets that are compressed in to holes in the gear housing.

  • The rivets need to be drilled out just a little bit to weaken them enough to pry off the cover. Begin this process by drilling the rivets about 1/4" deep with a small drill bit, smaller than 1/8".

  • Repeat with all four rivets.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.