Ga door naar hoofdinhoud

Stap 1 vertalen

Stap 1
Remove 4 Phillips screws located on the back side of the holding plate. After the screws are removed, remove the case of the development programmer. Carefully take out the circuit board with component side facing up. Put the case aside.
  • Remove 4 Phillips screws located on the back side of the holding plate.

  • After the screws are removed, remove the case of the development programmer.

  • Carefully take out the circuit board with component side facing up. Put the case aside.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.