Repareer je spullen Gemeenschap Winkel

iPhone 5s Display Einheit ersetzen

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 32 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Duits
Stap 10
iPhone 5s Front Panel Assembly Replacement: stap 0, afbeelding 1 van 2 iPhone 5s Front Panel Assembly Replacement: stap 0, afbeelding 2 van 2

  • During reassembly, you will need to reinstall the Touch ID cable bracket. The top of the bracket needs to slide between the battery and Touch ID cable connector, in front of the metal tab. The bottom must latch down over the connector.

  • Slide the top of the bracket over the Touch ID cable connector from left to right.

  • Alternatively, lay the bracket directly over the connector. The edge with the "leg" will prop the bracket up at a slight angle, and the opposite edge must be between the cable connector and the metal tab near the battery. With the edge of a spudger flat against the bracket, apply gentle downward pressure to snap in the back and front clasps.

Beim Wiederzusammenbau musst du die Touch ID Kabelhalterung wieder einsetzen. Die obere Kante der Halterung muss sich vor die Metalllasche zwischen den Akku und dem Kabelstecker des Touch ID Kabels schieben. Die Unterkante muss über dem Stecker einrasten.

Schiebe die Oberseite von links nach rechts über den Anschluss des Touch ID Kabels.

[* icon_reminder] During reassembly, you will need to reinstall the Touch ID cable bracket. The top of the bracket needs to slide between the battery and Touch ID cable connector, in front of the metal tab. The bottom must latch down over the connector.
[* icon_reminder] Slide the top of the bracket over the Touch ID cable connector from left to right.
+[* icon_note] Alternatively, lay the bracket directly over the connector. The edge with the "leg" will prop the bracket up at a slight angle, and the opposite edge must be between the cable connector and the metal tab near the battery. With the edge of a spudger flat against the bracket, apply gentle downward pressure to snap in the back and front clasps.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.