Ga door naar hoofdinhoud
Stap 5
The volume knob is simply pressed onto the splined volume control shaft. Use a plastic opening tool to pry evenly around the edge of the volume knob until you can remove it from the chumby.
  • The volume knob is simply pressed onto the splined volume control shaft.

  • Use a plastic opening tool to pry evenly around the edge of the volume knob until you can remove it from the chumby.

  • Volume control commands are sent via a rotary encoder that translates angular degrees of rotation into binary code recognized by the board.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.