Repareer je spullen Gemeenschap Winkel

iPhone 14 Plus Rear-Facing/후면 카메라 어셈블리 교체

Engels
Koreaans

Handleidingsbenodigdheden

Alle vooraf vereiste handleidingen moeten vertaald worden voordat deze vertaling volledig wordt beschouwd.

iPhone 14 Plus Pentalobe/펜타로브/별나사 교체

여는 픽을 3mm에 표시하기

iPhone 14 Plus 후면 유리 교체

Handleidingsinformatie

= Klaar = Onvolledig
    Use this guide to replace the rear-facing camera assembly in an iPhone 14 Plus.
    This guide was created using the ***A2886*** (international) model. If you're fixing a different iPhone 14 Plus model, there may be some visual discrepancies, but the procedure should be the same.
    ***Note***: On iOS 18 and newer, you can calibrate new, genuine camera modules using Apple's [link|https://support.apple.com/en-us/120579|Repair Assistant|new_window=true].
    You’ll need replacement adhesive to reattach the screen when reassembling the device. Your device will function normally, but will most likely lose its IP (Ingress Protection) rating.
      If possible, turn on your device and test your repair before installing new adhesive and resealing.
      Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.
      ***To reassemble your device, follow these instructions in reverse order.***
      After your repair, depending on the replacement part, you may be able to [link|https://support.apple.com/en-us/120579|calibrate it using Apple's Repair Assistant|new_window=true], available as of iOS 18. Update your device, navigate to Settings ***→*** General ***→***About ***→*** Parts & Service History, tap Restart & Finish Repair, and follow the onscreen prompts.
      Take your e-waste to an [[E-Waste|R2 or e-Stewards certified recycler|new_window=true]].
      Repair didn’t go as planned? Try some [[Troubleshooting Problems After a Repair|basic troubleshooting]], or ask our [link|https://www.ifixit.com/Answers/Ask/iPhone+14+Plus|Answers community] for help.

      Stappen

      Stap 1 — 후면 카메라 어셈블리 분리하기

      Spudger/스퍼저를 사용하여 소켓에서 커넥터를 똑바로 들어 올려 후면 카메라 어셈블리 케이블 두 개를 분리하세요.

      Stap 2 — 후면 카메라 어셈블리 나사 풀기

      Phillips/십자 드라이버를 사용하여 후면 카메라 어셈블리를 고정하는 2.1mm-길이의 나사 세 개를 풀어주세요.

      Stap 3 — 후면 카메라 어셈블리 들어 올리기

      후면 카메라 어셈블리 상단 가장자리 밑에 Spudger/스퍼저의 뾰족한 끝을 끼우세요.

      Stap 4 — 후면 카메라 어셈블리 분리하기

      핀셋 또는 손가락을 사용하여 후면 카메라 어셈블리를 분리하세요.

      Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.