SONY WH-CH700N bluetooth headphones USB charging port Replacement

Engels

Nederlands

Stap 8 vertalen

Stap 8

Desolder the USB connector

Grab the connector with tweezers and apply heat from the mounting pins' side (bottom).
Be careful with the hot air station and position the board in a way that you do not burn the jack connector while heating up the port.
320 degrees (Celsius) with 20-30% airflow is more than enough to get the connector off.
Clean the pads with a solder wick.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.