Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 6 handleidingen die deze stap bevatten.

Stap 1 vertalen

Stap 1
Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver. During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.
  • Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.

  • During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.

Entferne die acht Y1 Tri-Wing Schrauben von der Gehäuserückseite.

Halte beim Zusammenbau die Gehäuseteile fest zusammen, während du die Schrauben hineindrehst.

-[* black] Remove the eight 9-mm Tri-Wing screws on the back panel with the Tri-wing Y1 screwdriver.
-[* icon_note] During reassembly, firmly hold the panels of the controller together while replacing screws so the panels don't separate.
+[* red] Remove the eight 9 mm screws from the back panel using the Tri-point Y1 screwdriver.
+[* icon_reminder] During reassembly, firmly hold the panels of the controller together while replacing the screws so the panels do not separate.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.