Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Engels
Nederlands

Stap 1 vertalen

Stap 1
Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit. Carefully disconnect the fan connector from the socket, as depicted in the second picture.
  • Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit.

  • Carefully disconnect the fan connector from the socket, as depicted in the second picture.

  • The controller connector panel can be gently pulled out of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.

  • Make sure to not pull out the wires while removing the fan. Doing so may damage the connector wire or the PCB.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.