Ga door naar hoofdinhoud
Engels
Nederlands

Stap 2 vertalen

Stap 2
Use the flat end of a spudger to pry up the fingerprint sensor cables adhered to the inside of the back cover. If the adhesive is too strong, use an iOpener to apply heat to the back cover for one minute and try again. Remove the fingerprint sensor.
  • Use the flat end of a spudger to pry up the fingerprint sensor cables adhered to the inside of the back cover.

  • If the adhesive is too strong, use an iOpener to apply heat to the back cover for one minute and try again.

  • Remove the fingerprint sensor.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.