Ga door naar hoofdinhoud
Stap 19
The only seam to be found is where the rubber meets the metal, making that the obvious entry point. Optimistically, we blast it with some heat in order to soften the adhesive which, presumably, holds this thing together. Then we attach two perfectly-fitting suction cups, one to either side, and start tug-of-warring. The white cover material on the charging surface starts to stretch slightly, but the actual gap doesn’t budge. (Sometimes we're too optimistic.)
  • The only seam to be found is where the rubber meets the metal, making that the obvious entry point.

  • Optimistically, we blast it with some heat in order to soften the adhesive which, presumably, holds this thing together. Then we attach two perfectly-fitting suction cups, one to either side, and start tug-of-warring.

  • The white cover material on the charging surface starts to stretch slightly, but the actual gap doesn’t budge. (Sometimes we're too optimistic.)

  • So, under the knife it goes! Some persuasion from our razor knife gets us past the white cover, between the plastic and metal underneath, where we can start prying.

外側から確認できるシームは、ゴムとメタルが繋がる場所です。ここが確かな侵入ポイントです。

両側を固定している接着剤を温めればいいと楽観的に考えて、熱を当てます。完璧にフィットする吸盤カップを両側に装着して綱引きをします。

充電器表面のホワイトカバーがわずかにストレッチしますが、実際は微塵だにしません。

それならばナイフの出番です!私たちの精密ナイフでプラスチックとその下のメタルの白いカバーを露出させます。ここから内部をこじ開けます。

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.