Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 14 handleidingen die deze stap bevatten.
Stap 7 vertalen
Stap 7
-
Insert an opening pick into the lower-left corner of the rear panel.
-
Using another opening pick, cut the adhesive along the left edge of the rear panel.
+ | [* icon_caution] Be careful near the corners, as the glass is weakest there. |
---|---|
[* black] Insert an opening pick into the lower-left corner of the rear panel. | |
[* black] Using another opening pick, cut the adhesive along the left edge of the rear panel. | |
- | [* icon_caution] |
+ | [* icon_caution] Don't insert an opening pick in more than halfway on the left edge near the fingerprint sensor or you may damage the ribbon cable inside. |
[* icon_note] It is fine if opening picks fall out as the back cover becomes separated. |
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.