Ga door naar hoofdinhoud
Stap 19
Use a T8 Torx driver to remove the two remaining 5.0 mm hinge screws (one from each hinge). Remove the topmost screw last, using one hand to steady both halves of the MacBook Pro to make sure they don't separate and fall over unexpectedly. Remove the topmost screw last, using one hand to steady both halves of the MacBook Pro to make sure they don't separate and fall over unexpectedly.
Remove the remaining hinge screws
  • Use a T8 Torx driver to remove the two remaining 5.0 mm hinge screws (one from each hinge).

  • Remove the topmost screw last, using one hand to steady both halves of the MacBook Pro to make sure they don't separate and fall over unexpectedly.

Benutze einen T8 Torx Schraubendreher, um die beiden übrigen 5 mm Scharnierschrauben zu entfernen (eine von jedem Scharnier).

Entferne die oberste Schraube zuletzt, und stütze dabei die beiden Hälften des MacBook Pro mit einer Hand ab, um sicherzustellen, dass sie sich nicht voneinander lösen und umkippen.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.