Ga door naar hoofdinhoud
Engels
Nederlands
Stap 3
With the Torx screws removed, the touchpad along with the circuit board and the door latch will flop open.  I used a stool about 3 feet high to rest it on.  The wires from inside the door are attached, so it will dangle in mid-air without the stool.  The stool makes it easy to work on the replacement. There is a black plastic cover over the latch mechanism and circuit board.  There are 3 plastic tabs that hold the black cover in place.  In the second picture, I have circled one on the left in Red.  There are two on the right side. (the tab circled in Blue holds the latch mechanism, that's later in this procedure.)
Remove the inside plastic cover
  • With the Torx screws removed, the touchpad along with the circuit board and the door latch will flop open. I used a stool about 3 feet high to rest it on. The wires from inside the door are attached, so it will dangle in mid-air without the stool. The stool makes it easy to work on the replacement.

  • There is a black plastic cover over the latch mechanism and circuit board. There are 3 plastic tabs that hold the black cover in place. In the second picture, I have circled one on the left in Red. There are two on the right side. (the tab circled in Blue holds the latch mechanism, that's later in this procedure.)

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.