Ga door naar hoofdinhoud
Engels
Nederlands
Stap 3
Hopefully you've already obtained replacement batteries.  Anything with a tab can be made to work.  Here it's a 2/3A size battery with PC board pins.  Not an exact match, but close enough. To cut the old battery out: use strong side cutters and a back and forth motion.  Leave enough of the tab you can solder to it later. To remove using a hot/powerful iron: take out three more screws to remove the circuit board.  Heat up each tab in turn and pull up on the battery.   Leave as much solder as possible in the hole for later.
Replace Batteries
  • Hopefully you've already obtained replacement batteries. Anything with a tab can be made to work. Here it's a 2/3A size battery with PC board pins. Not an exact match, but close enough.

  • To cut the old battery out: use strong side cutters and a back and forth motion. Leave enough of the tab you can solder to it later.

  • To remove using a hot/powerful iron: take out three more screws to remove the circuit board. Heat up each tab in turn and pull up on the battery. Leave as much solder as possible in the hole for later.

  • Double check the power switch is off, and the polarity. Finally, solder the new battery in.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.